My system only comes on in reverse. It will not come on manually via the remote.
This is typically the result of incorrect wiring at the controller Areas to look at include:
| |||
|---|---|---|---|
| Yes | No | ||
Step 1 |
Check the wiring at the controller. Are the red and blue wires tied together? Red should be connected to a post ignition power source and blue to the reverse gear circuit. |
Correct wiring and retest |
Go to step 2 |
| Step 2 | Does the remote beep when voltage is applied and are the buttons lit up? | Go to step 3 | Go to step 4 |
| Step 3 | Are you using the correct remote? CVR100 when using a CVS100 or CVS102 controller and a CVR500 when using a CVS500 controller. | Go to step 4 | Replace with the correct remote and retest |
| Step 4 | Check your connections at the remote and the display to controller cable. Make sure they are not damaged and are connected properly. Is the cable, connections and remote okay? | Go to step 5 | Reconnect and/or replace as necessary and retest |
| Step 5 | Contact your INTEC Service Rep. They may ask you to return your remote control, controller and display to controller cable for service. | ||